A corner apartment can be found at the end of the building: this is, a part of its walls aren’t adjacent to the neighbours, however would be the outer walls of the house.

There might be one flat in a corner apartment – it occupies the entire end of the house, it is likewise called a corner flat. Or 2 – that the windows of a single overlook the street, the second – the lawn. Depends on the building plan, the layout of the premises.

There’s also a”separate caste” – casing with walls at the expansion joints. These”gaps” between entrances are ordinarily made in multi-story buildings, the most important undertaking of the unit – to split the deformation forces through the shrinkage of this construction, in case of crises. Pros and cons of both corner flats at the joint are somewhat different from the typical ones with access to this road – we’ll pay special attention to the subject in the past section.


Considering that the 2-3 sides of the space is outdoors, in winter it is 3-5C colder, and in summertime on the contrary – hotter. Especially if the conclusion of the home is heated from the sun. In some cases, the gap reaches 10C – however such a difference is unacceptable, indicates a problem with the exterior the house – most probably have to speak to the management firm, asking domikday.ru (or forcing) to fulfill their immediate duties, to spot the cracks formed.

Corner flat in a brick home with thick walls is more comfy. Such dangers are not exposed – the thickness of the wall acts as a buffer, so not allowing overheating, overcooling.


When an area has just one wall combined with the road, it usually has enough room heat to avoid freezing and warmth. But if there are two outdoor walls, and they’re adjacent – there is a higher probability of freezing at the corner, the creation of condensation inside, and therefore – mold, fungus. Their spores not only spoil the appearance of the room, but also cause the look, complication of many serious diseases.

Important! The problems of corner place are justified when the variables are related – also low temperature from heating batteries combined with dampness is guaranteed to result in moldy walls.