Step-by-step directions to gluing inner corners

When completing, the major problem can be uneven walls and the consequent folds on the background. It’s also essential to take into account that if the walls are crookedthe joints of wallpaper canvases may diverge.

After gluing the previous one in the front of the interior corner of the fabric should measure the remaining space. It is measured from the edge of the pasted cloth to the adjoining wall, and the resulting amount is added 10-15 millimeters. If the walls are extremely curved, then the further figure could be .

Cut a strip equivalent to the resulting figure, taking into account the allowance. The surfaces have been treated with adhesive. Depending on the kind of coat it can be precisely the wall or surfaces.

The strip has been glued independently with the cut side into the wall. The background should go on the other plane.

If the glued background is wrinkled, you have to make several smallish cuts perpendicular to the gidpola.ru folds.

Level or slope on the adjoining wall is a vertical line. The distance in the corner is equivalent to the width of the previous cut strip, never adding additions.

The surfaces are smeared with adhesive, and the coating is glued to the wall using the flat side to the marked line. The cut goes onto the adjoining wall.

Protruding corner should be pasted by analogy with an inner, but there are small differences, which also have to be taken into account when working.

Measured the space remaining in the glued wallpaper to the adjoining wall. Insert 20-25 millimeters to the obtained figure.

A segment is cut away, taking into account the additional 20-25 millimeters.

Prior to gluing, the surfaces are treated with adhesive.

The even edge must be glued into the background already fixed on the walls, the own cut facet”extends” to the adjoining plane. If necessary, small cuts are made in the area of going to another wallpaper, smoothed and pressed into the wallsocket.

Draw a vertical strip onto the adjacent wall in a distance of just glued cut strip plus 6-10 millimeters.

After applying the adhesive, the strip is applied to the wall using its flat side to the marked line, moving over the border of this glued strip.

The joints are smeared with adhesive and ironed using a rollercoaster. Following that, the upper layer is trimmed across the ruler and the 2 layers are combined together.